Emerson XWEB3000 EVO Operating Manual page 17

3. Specify whether or not the system must run the search by controlling the silence time. The enabling of
this parameter allows for the stopping of the search procedure should noise be detected on the line.
If in doubt as to whether or not to enable this function, disable it.
4. Specify the Modbus range of addresses to be detected
5. Press "Start search" to run the operation.
The search results may display the list of detected devices that can be added to the network configuration.
The presence of the system device library is indicated in the "Library" column with the symbol
missing library must be installed should another symbol be displayed.
The name of the device and the group of pertinence can be configured when the row is selected (as shown
below).
To confirm the configuration of the devices, select them and press "Apply".
Attention: from this window it is not possible to replace the set-up of controllers already present in the
configuration. If at least one of the selected addresses is already present in the "Device List", you will receive
an error message:
If you have changed a physical device and need to replace it in the system configuration, you must first
remove it from the device configuration.
B. ADD/REMOVE DEVICES, MANUAL SETTING
The association with the instrument network configuration can be manually added or removed to/from the
controller devices by the user. You must access the "Add/Remove Device(s)" tab.
The list of all the libraries in the system is displayed in this window.

Add a device
1. Select the library to be used from the list:
1592010880 XWEB3000_5000 EVO OPR GB r1.0 2014.11.28
. The
17/100