Whirlpool Automatic Ice Maker User And Care Manual page 6

Setting the controls
1. Select ice thickness. The ice maker has
been preset to produce ice approximately
l/2" (13 mm) thick, while operating in a
room temperature of 70°F (21 "C).
Operation in different room tempera-
tures may require readjusting the Ice
Thickness Control Knob toward "THICK"
or "THIN."
Best operation will be obtained with ice
%" (13 mm) to ,h" (16 mm) thick.
If operating in a warm room (above 90°F
[32"C]) do not set control to maximum
thickness or the unit may malfunction.
2. To start the normal ice making cycle, turn
the Cycle Control Knob to "ON."
3. To stop ice maker operation, turn Cycle
Control Knob to "OFF."
The "CLEAN" setting is used whenever solu-
tions are circulated through the ice maker for
cleaning. Only the water pump operates at
this setting. See "Cleaning the ice maker
system" on page 11 for specific instructions.
Changing the bin door panel
You can easily change the color of the front
panel on the storage bin door. Two colors
are available: Black and White.
To change bin door panel:
1. Open the storage bin door. Remove the
2 screws on the top of the door, which
hold the handle.
2. Loosen the screws in both of the side trim
pieces.
3. Remove the handle and the handle insert.
Screws
(both
sides)