Electronic Oven Control; Start/Enter; 14. Off/Cancel; Clock - Kenmore 665.72002 Use And Care Manual

ELECTRONIC OVEN CONTROL
3 4 5 6
19
loll Mm
7 8 9 10 11 12 13 14
1. RECIPE RECALL
TM
_on some models]
2. Display
3. Clock
4. Time-
5. Cooktop Lockout ,on some models)
Cooktop Light ion some modelsJ
6. Oven Light/Oven Lockout
7. Oven Selectors (SERVE WARM on
some modelsi
8. Self-Clean
SENS-A-CLEAN
TM
_oesome models]
LOGI-CLEAN
TM
Ion some models)
SELECT CLEAN
TM
[on some modelsl
CLEAN _on some models]
9. TemDerature Setting
10. Timed Cooking
11. Hour
12. Minute
13. STARTJENTER
14. OFF/CANCEL
Di
When Dower is first SUDDIied tO the appliance make sure tee
surface burners are in the OFF pos[uon Everything on the dEsplay
will light up for 5 seconds Then the time "PF" will aDDear on the
a_sp[ay.
Any omer ume "PF" appears, a Dower failure occurred, To
remove "PF" and to reset the clock. Dress OFF/CANCEL
When the oven is in use. this display shows time. temperature
and what command pads have been aressed
When the oven is not in use. the disDlay Will show the time of day.
The START/ENTER Dad begins any oven function If not Dressed
within 5 seconds after pressing a pad. "START?" will aDDear on
the diSDlay as a reminder. If not Dressed within 5 minutes after
Dressing a DaG the display, will show the time of day and the
programmed function will be canceled
The OFF/CANCEL pad stops any oven function except for the
Clock Timer and CooktOD or Oven Lockouts.
AfTer pressing OFF/CANCEL the display will show the time of
Day or, if the minute timer is also Deng used the time remaining.
This is a 12-hour clock and does not show a,m, or p.m
To Set:
1. Press CLOCK.
2. Press the HOUR/MIN "UD" or "down" arrow pads until the
correct time of day snows on tee display.
3. Press CLOCK or START/ENTER,
[O_@S
]-ones are audible signals, indicating Lhe following:
One tone
• Valid Dad Dress
• Oven is preheating or has been preheated
• Function has been entered
Three tones
• Invalid Dad Dress
Four tones
•
End-of-cycle
• Rem[nden repeaung each minute after the end-of-cycle tones
Error Tones
Error [ones indicate a oroblem with the electronic oven control.
An error code will appear in the display.
10