Warming Drawer - Kenmore 665.72002 Use And Care Manual

To Replace:
1. Grasp the door on the sides with your fingers on the front of
[he door and your thumbs on its inside surface
2. Hold oven door so that the top edge of each hinge hanger is
horizontal mser[ hinge hangers into the front frame nmge
Slots.
3. Tilt tc a of door toward range. Slide hinge hangers down omo
_'Dnt frame suPPort 3ins, Make sure the hinge hangers are
fully seated and engaged on the SUDDO[[Dins,
1
2
3
7. Hinge hanger
2. Door frame hinge
3. Support pros
4. Insert the door stop clip with its angular surface at the tc a of
[he frame hinge slot, then push in the bottom of the clip until
its flanges are flush with the front frame
5. ODen the door completely and remove the door removal Dins,
Save door removal pins for future use.
6. Close the aoor.
Storage D['awer
Thestoragearawercan beremoved Before removing, makesure
drawer ts cool and emD[y,
To Remove:
1. Pull drawer straight out to the first stop
2. Lift up the back of the drawer and pull out
To Replace:
1. Fit the ends of the drawer ra_ls into the guides in the cavity.
2. Slide the drawer closed
Warm n9 D awer
Remove all items from inside the warming drawer and allow the
unit to cool completely before attempting to remove the drawer.
To Remove:
1. Open drawer to its full open posE=on
2. Locate the black triangle-shaped tabs on both sides of the
arawer.
3.
1 Tab
Press the tab down on the right s_de. and lift tab UD on the left
side at the same time, then Dull drawer out another inch
4. Holding the drawer by =tss=des, not its front carefully pull it
all the way out
To Replace:
1. Align the drawer glides with the receiving guides.
2. Push drawer in all the way
3. Gently open and close the drawer to ensure it is seated
properly on the slides
23