Connections And Addressing - ETC Source Four Revolution User Manual

C o n n e c t i o n s a n d A d d r e s s i n g
Connect AC input power and DMX data cables to the appropriate ports as shown below.
Connect the incoming DMX data cable to the DMX Input connector. If you are daisy-
chaining the data to other fixtures or DMX-controlled devices, connect the next DMX cable
to the DMX Thru connector. Revolutions built prior to 2007 (Part Number 7160A1002)
require that the last fixture on a DMX line be terminated with a 100Ω resistor between pins
2 and 3. Revolutions built in 2007 or after are self-terminating and do not require
termination. If both types are used on the same DMX line, it is recommended that the line
be terminated.
Use the three thumbwheels on the upper enclosure to set the starting address for the
fixture. Addresses must be set between 1-481. The fixture will report an error if the address
is set to 482 or above. See
N o t e :
Revolution is a 31-channel fixture. A fixture with a starting address higher than 481 will
not have control of all parameters.
Thumbwheels
DMX Thru
DMX Input
Power Switch and
Breaker
AC Input
®
(Neutrik PowerCon
connector)
Connect the AC Input cable:
Align and insert the power connector. Twist the connector clockwise until it locks into place.
Disconnect the AC Input cable:
Slide back the locking tab, twist the connector counterclockwise and pull to unlock and
disconnect the power connector.
8
Control, page
I
O
®
Rear Bay
Front Bay
10, for channel mapping.
Source Four Revolution User Manual
LEDs
Pan Lock
Tilt Lock