Table of Contents
Advertisement
Leader Roller
Replacement
Gel String
Line on Label
Removing the gel string:
Step 1:
Step 2:
Step 3:
Installing a gel string:
Step 1:
N o t e :
Use only Gaffer's P665 tape to attach the gel string. Do not use duct or masking tape.
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
Routine Maintenance
Scroller shown face up
Using your finger, turn the trailer roller drive wheel (hook and loop pad) at the
bottom of the scroller clockwise and wind the gel onto the trailer roller.
Gently untape the gel from the leader roller.
Carefully pull the gel from the trailer roller and roll the gel up tightly, untape the
trailer from the roller, and tape the gel roll for storage.
Place the new gel string roll on the leader roller side of the scroller and attach a
76 mm (3") strip of Gaffer's tape length-wise so that half of it extends past the
end of the trailer. The long tag on the gel should be facing up.
Center the edges of the trailer on the trailer roller and secure it with the tape.
While applying gentle pressure to the gel string, turn the trailer roller drive wheel
(hook and loop pad) at the bottom of the scroller clockwise and wind the gel onto
the roller. Make sure the gel stays centered on the roller.
When you reach the end of the gel, gently pull on it while holding the roller drive
wheel to take the slack out of the roll.
Attach a 76 mm (3") strip of Gaffer's tape length-wise so that half of it extends
past the end of the leader. Maintain tension on the roll.
With your other hand, turn the leader roller clockwise until the black line on the
roller label is facing up.
Trailer Roller
Top
Gaffer's
Tape
Trailer End and
Long Tag
Hook and Loop Pad
29
Advertisement
Table of Contents
