Receiving The Security Key Of Another Io-Homecontrol Control; Creating A New Security Key In Velux Integra Control Pad Klr 200 - Velux KLR 200 User Manual

®
VELUX INTEGRA
KLR 200
Setting up
Extension of your VELUX INTEGRA
Receiving the security key of another io-homecontrol
®
io-homecontrol control
A
Press the key button for 2-7 seconds until the diode starts flashing
(3 flashes per sec).
Note: The transfer can be interrupted by pressing the key button
once more.
®
VELUX INTEGRA control pad KLR 200
Tap to ensure that the control pad display is on.
Press the key button briefly (max 2 seconds) until the diode starts
flashing slowly (1 flash per sec).
When the diode on your control pad KLR 200 stays green for
about 2 seconds and then goes out, the transfer has succeeded.
If the diode on your control pad KLR 200 flashes red quickly three
consecutive times
has failed. In this case, you must repeat the process with both
controls.
When the security key has been received, you have to add the
products from io-homecontrol ®
Please refer to the section Adding products to the control pad.
Creating a new security key in VELUX INTEGRA
KLR 200
Tap to ensure that the control pad display is on.
Note: All products in the control pad must be operable; otherwise
they will not be operable with a new security key either. Therefore
please make sure that all products are connected to power and
within range before continuing.
Press the key button for 7-15 seconds until the diode starts
flashing very fast (7 flashes per sec).
When the diode on your control pad KLR 200 stays green for
about 2 seconds and then goes out, the creation has succeeded.
If the diode on your control pad flashes red quickly three con-
secutive times and then turns off, the creation has
failed. Some products are now not operable with this control pad
anymore.
®
system - Joint operation of io-homecontrol
®
control
and then goes out, the transfer
control to control pad KLR 200.
A
® control pad
®
products
KEY
A
3
VELUX 97