Start-Up Of A New System; If The Initial Set-Up Fails - Velux KLR 200 User Manual

®
VELUX INTEGRA
KLR 200
Setting up
Start-up of a new VELUX INTEGRA

If the initial set-up fails

If the control pad cannot find some of the products, you can make the products ready for registration by manually resetting them to their
initial factory settings.
Note: Reset products cannot be operated until they have been registered in the control pad. See the section Initial set-up.
Products can be reset in different ways, depending on window type.
Note: Contact your local VELUX sales company for reset of products not shown.
Centre-pivot windows
Open window manually (if the window is already open, close it
1
by pressing the test button on the window operator).
Press the test button on the window operator for at least
2
10 seconds.
The window operator and other electrical products on the
window will run briefly back and forth. Frame lights, if installed,
will flash briefly.
Flat roof windows
Carefully remove the cover cap on the kerb.
1
Press the test button on the window operator behind the cover
2
cap for at least 10 seconds.
The window operator and other electrical products on the
window will run briefly back and forth. Refit cover cap.
Modular skylights
Remove bottom flashing section from the modular skylight and
1
unscrew the small, right-hand cover of the control unit.
Press the reset button in the control unit for 6-10 seconds.
2
Screw on the cover again and refit bottom flashing section.
Note: As registration in the control pad must take place within
10 minutes, you are advised to register the products before refit-
ting bottom flashing section.
®
system
1
1
1
3
2
2
2
VELUX 39