Velux KLR 200 User Manual page 44

®
VELUX INTEGRA
KLR 200
Setting up
Extension of your VELUX INTEGRA
®
Adding a VELUX INTEGRA controller KRX 100 to your system
already operated with a control pad KLR 200
The instructions below show how to copy the contents of control
pad KLR 200 to controller KRX 100. See also the instructions for
the controller.
Note: Only available for VELUX INTEGRA
frequency 868 MHz.
Control pad KLR 200 to send a copy is called control
Controller KRX 100 to receive a copy is called control
First execute items 1-3 with
B
1
B
LANGUAGE
2
Dansk
English
B
Français
Deutsch
Enter
P1 P2
®
system - Adding a control
® products with radio
.
A
.
B
.
RESET
Select language:
Press to highlight your
language.
Press "Enter" to confirm
your choice.
A
Connect to mains supply:
Remove the back cover of the controller as shown. Click the adap-
tor plug into the controller and replace the cover. Connect the
adaptor to mains supply.
Note: The controller saves the selected settings even if the mains
supply is disconnected. Therefore, it is advisable not to fit the
controller permanently until the sunscreening products and the
sensors have been registered in the controller.
However, time and date are only saved for 30 seconds after dis-
connection of mains supply.
SET TIME
3
B
11:0 0
Enter Back
P1 P2
3
B
Set time:
Press to set minutes.
Press "Enter" to change to
hours.
Press to set hours.
Press "Enter" to confirm
your settings.
Continue on the next page
VELUX 44