Care And Maintenance - Russell Hobbs 18970-56 Instructions And Warranty


To avoid unnecessary splashing, immerse the mixing leg and blade into the
mixture before switching the appliance ON.

The speed can be adjusted at any time. Use the LOW speed setting for the thicker
consistency. Use the HIGH speed setting for finer consistency.
THE WHISK (MODEL 18980-56)
1. Push the whisk into the bottom of the whisk holder.
2.
To remove it, simply pull it out of the bottom of the whisk holder. Do not immerse
the whisk past the top of the wires.
THE CHOPPER (MODEL 18980-56)
1. Use the chopper as a mini-food processor (max 450ml).
2. Lower the spindle into the bowl.
3. Turn the spindle to engage the slots underneath it with the tabs in the bottom of
the bowl, then press it firmly into the bottom of the bowl.
4. Hold the chopper by the plastic part.
5. Lower it into the bowl, over the spindle.
Add the ingredients – don't fill the bowl above the 450ml mark.
6.
7. Lower the bowl lid into the top of the bowl, so that the chopper fits into the drive in
the underside of the lid.
8. Plug the handle into the wall socket, hold the bowl steady, and start blending.
9. Use the chopper in short bursts.
Chop, stop, then look – repeat until you achieve the required consistency.
10.
11. Unplug the handle, then remove the handle from the lid.
Lift the lid from the bowl – take care that any drips fall into the bowl.
12.
Lift out the blade by the plastic part – don't handle the blade.
13.

CARE AND MAINTENANCE

NOTE: Use extreme care when handling the blade at the bottom of the mixing leg. Do
not touch the blade with your fingers. The blade is very sharp and can cause injury.

Make sure the unit is unplugged from the main power supply.

Disconnect the blending tool from the motor.

It is much easier to clean the accessories directly after their use.

Wash in warm, soapy water, rinse and dry well.
9