Russell Hobbs 18970-56 Instructions And Warranty page 3

CAUTION: Please use your hand blender for no longer than 3-minutes at a time. For
model 18980-56, the stick blender set, don't use the whisk for more than 5-minutes or
the chopper for more than 30 seconds. Once using the unit for the max recommended
amount of time, switch your hand blender off for 3-minutes to let the motor cool and
avoid possible damage. We suggest these usage times to help keep your product
working for years to come.
1. Please read the instructions carefully before using any appliance.
2. Always ensure that the voltage on the rating label corresponds to the mains
voltage in your home.
3. Incorrect operation and improper use can damage the appliance and cause injury
to the user.
4. The appliance is intended for household use only. Commercial use invalids the
warranty and the supplier cannot be held responsible for injury or damage caused
when using the appliance for any other purpose than that intended.
5. Avoid any contact with moving parts.
6. The blade on the mixing leg is sharp and rotates at a high speed. To avoid serious
injury:

Don't switch the unit on until the blade is inside the container.

Switch off before lifting the blade from the container.

Don't touch the blade – even when cleaning.

Don't plug in till just before use.

Unplug immediately after use.

Don't leave the appliance unattended while plugged in.
7. When using the mixing leg in hot liquids, don't let the blade break the surface at an
angle, in case you spray liquid outside of the container.
When using the mixing leg in hot oil – splashes can cause a nasty burn.
8.
9. Don't try to chip ice or chop raw meat.
10. Rotate the cable so it doesn't overhang, and can't be tripped over or caught.
11. Take great care when handling the chopper (model: 18980-56).
12. Close supervision is required when any appliance is used near or by children or
invalids.
13. Check the power cord and plug regularly for any damage. If the cord or the plug is
damaged, it must be replaced by the manufacturer or a qualified person in order to
avoid an electrical hazard.
3