Russell Hobbs 18970-56 Instructions And Warranty page 7

FITTING OR REMOVING ATTACHMENTS
1. Unplug the appliance before fitting or removing the mixing leg.
2. To fit the mixing leg, push it on to the end of the handle, and turn it clockwise to
lock it in place.
3. To remove the mixing leg, turn it anti-clockwise, then pull it off the handle.
ATTACHMENTS
THE MIXING LEG
1. Generally, the mixing leg can do anything a normal blender can do, but faster, and
with less washing up – blend, pulp or purée ingredients in the pan or bowl you're
going to cook them in. Remember that this blender is an immersion type blender,
therefore all use must be whilst the blade part of the mixing leg is immersed or
pressed into the ingredients (inside the container) in which you wish to blend.
Whatever container you use, make sure it's on a stable, flat surface, and support it
2.
with your free hand, to prevent it moving.
3. Avoid spraying/splashing:
a) hold the mixing leg straight
b) don't switch on till it's inside the food container
c) switch off before lifting it out of the container
d) with liquids, switch on and off with the blade under the surface
THE BEAKER
Don't fill the beaker more than about half full.
1.
2. Sit it on a stable, flat surface, and support it with your free hand.
Don't lift it off the work surface and hold it in your hand – if it slips, you'll hurt
3.
yourself.
OPERATING INSTRUCTIONS
1. Carefully unpack your hand blender and take off any protective wrappings.
2. Clean the mixing leg and blade before using it for the first time with a moist cloth or
rinse under the tap. Make sure the unit is unplugged before doing this.
7