Care And Maintenance - Russell Hobbs 25710-56 Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
5.
Remove the lid.
6.
Put the ingredients into the jug. Don't fill past the 1500 ml mark. If you do, the contents may force the
lid off when you start the motor.
7.
Replace the lid. Don't operate the appliance without fitting the lid.
8.
Put the plug into the power socket.
Turn the speed control to the speed you want (1 = low, 2 = high).
9.
10. Turn the speed control back to O to turn the motor off.
Generally, large quantities, thick mixes, and a high ratio of solids to liquids require longer timings and
slower speeds.
Smaller quantities, thinner mixes, and more liquids than solids require shorter timings and higher
speeds.
Turning the speed control anti-clockwise to Y will give you a short burst at high speed. In this
direction, the knob is spring-loaded. When you let go, it'll return to O.
To add ingredients while the blender is working, remove the cap, pour the new ingredients through
the hole, then replace the cap.
Check that the added ingredients don't increase the volume in the jug past the 1500ml mark.
When you have finished:
1.
Switch off (O), and wait till the blades come to a stop before removing the lid from the jug, or
removing the jug from the motor unit.
2.
Turn the jug to align the d with the U to unlock it, and lift it off the motor unit.

CARE AND MAINTENANCE

1.
Switch the appliance off (O) and unplug it.
2.
Wipe the outside of the motor unit with a clean damp cloth.
3.
Hand wash the removable parts.
¬ You may wash these parts in the top rack of a dishwasher.
` You may wash these parts in the dishwasher.
If you use a dishwasher, the harsh environment inside the dishwasher will affect the surface finishes. The
damage should be cosmetic only, and should not affect the operation of the appliance.
BLADE UNIT
You may wish to remove the blade unit for cleaning.
1.
Remove the lid.
2.
Sit the jug upside down.
3.
Unscrew the collar from the jug and carefully remove the blade unit.
4.
Wash the blade unit in warm soapy water, rinse, and air dry.
5.
Replace the blade unit and screw the collar firmly onto the bottom of the jug.
RECYCLING
W
To avoid environmental and health problems due to hazardous substances, appliances
and rechargeable and non-rechargeable batteries marked with one of these symbols
must not be disposed of with unsorted municipal waste. Always dispose of electrical
and electronic products and, where applicable, rechargeable and non-rechargeable
batteries, at an appropriate official recycling/collection point.
4

Advertisement

Table of Contents
loading

Table of Contents