York Fitness CHALLENGER Omega X-Trainer Owner's Manual page 6

3. Attach the pedals to the posts
.1 Rotate both pedal post assemblies backwards so
that the pedal posts are resting on the floor as
shown.
.2 Attach the right pedal to the right pedal post and
secure, using two carriage bolts, washers, spring
washers and fixing knobs.
NOTE: The curved edge of each pedal must be
fixed onto the pedal post facing outwards.
. Attach the left pedal to the left pedal post and
secure, using two carriage bolts, washers, spring
washers & fixing knobs.
NOTE: There are three adjustable holes on
the pedal post for you to adjust the pedal to a
suitable position. MAKE SURE YOU FIX BOTH
PEDALS INTO THE SAME POSITIONS ON THE
PEDAL POSTS.
4. Attach the console
.1 Rest the front post on the front post mounting tube carefully as shown.
.2 Connect the sensor wire plug on the main frame to the middle wire socket protruding at the end of the front post.
. Check the middle wire runs up the front post and out of the top - this will connect to the computer later.
NOTE: Ensure the wire is connected as tightly as possible.
. Insert the front post into the front post mounting tube and secure, using four allen head bolts, spring washers and
washers. NOTE: Take care to ensure that the wire does not get trapped when you attach the front post.
.5 Fix the central handle bar to the front post via the fixing bracket using two allen head bolts, spring washers and
washers. NOTE: Ensure that the hand pulse sensor cables do not get trapped when you attach the centre bar. Make
sure you fasten the bolts securely for your safety and comfort when pedalling.
A
RIGHT
PEDAL
RIGHT
PEDAL
POST
CURVED
EDGE
OF PEDAL
THIS SIDE
BRACKET
POINTING
DOWN
CHALLENGER Omega X-Trainer | OWNER'S MANUAL • 7
B
LEFT
PEDAL
LEFT
PEDAL
POST