York Fitness CHALLENGER Omega X-Trainer Owner's Manual page 16

EXTrA InFOrmATIOn / ErrOr mESSAGE
The computer is equipped with an auto START/STOP
device. It will activate when you start to pedal and switch
off 256 seconds after you stop pedalling.
Error 1: (E1) Cable Connection Error
When the connection cables are not installed correctly,
the monitor will display "E1" on matrix display and
generate a beep sound.
Please examine weather all connection cables are well
connected and then reset the power to release the beep
sound or press START/STOP key 2 seconds to restart the
system.
Error 2: (E2) Loading Error
When your load value is incorrect or the EEPROM IC is
damaged, the monitor will display E2 on matrix display.
Error 3: (E3) Hand Pulse Sensor Error
The monitor can not read pulse signal properly when you
press the pulse recovery button, the monitor will display
E.
**Holding the START/STOP key for 2 seconds will quit the
error message and will enter to the initial mode.
Should you require any assistance regarding this
product please contact york directly.
CHALLENGER Omega X-Trainer | OWNER'S MANUAL • 17