Features - HP procurve Installation Manual

Features

Link and Mode LEDs
(one pair per port)
1 2
7 8
1
hp procurve
10/100-TX
gl module
J4862B 7
2
Contact your HP-authorized networking products reseller or your HP repre-
sentative for information on availability of other modules, transceivers, and
mini-GBICs. You can also visit the HP networking products Web site at http:/
/www.hp.com/go/hpprocurve to get more information.
Features
3 4 5 6
9 10 11 12
10/100-TX Por ts (1-24)
network ports
Example: The HP Procurve 24-Port 10/100-TX GL Module
The HP Procurve Switch GL Modules have the following features:
auto-enabled ports—the ports are all configured to be ready for network


operation as soon as a viable network cable is connected.
auto-configuration—a default configuration is applied to the module


when the switch is powered on and the module passes self test; this default
configuration works well for most network installations.
LEDs that provide information on the link status, network activity,


connection bandwidth, and communication mode (half or full duplex).
"hot swap modules" operation—you can add a module or replace a


module without having to shut down the switch (changing the module
type in a given slot does require a switch reset).
"hot swap transceivers" operation—you can add, replace, or change the


type of any of the transceivers and mini-GBICs that you use in the Gigabit
Transceiver GL Module and mini-GBIC GL Module, without having to first
remove the module, and without having to shut down the switch.
13 14 15
Link|Mode
19 20 21
Link|Mode
12 19 all por ts are HP Auto-MDIX
retaining screw
16 17 18
22 23 24
18
module
24
gl