Advertisement
Quick Links
USER
MANUAL
MODEL 1010B
Miniature, High Speed
Short Range Modem with
Transformer Isolation
Part# 07M1010B-C
Doc# 039041UC
Revised 03/13/00
C E R T I F I E D
An ISO-9001
Certified Company
SALES OFFICE
(301) 975-1000
TECHNICAL SUPPORT
(301) 975-1007
http://www.patton.com
Advertisement
Related Manuals for Patton electronics 1010B
Summary of Contents for Patton electronics 1010B
- Page 1 USER MANUAL MODEL 1010B Miniature, High Speed Short Range Modem with Transformer Isolation SALES OFFICE Part# 07M1010B-C (301) 975-1000 Doc# 039041UC Revised 03/13/00 TECHNICAL SUPPORT C E R T I F I E D (301) 975-1007 An ISO-9001 http://www.patton.com Certified Company...
-
Page 2: Radio And Tv Interference
The Model 1010B has been tested and found to comply with the limits for a Class A computing device in accordance... - Page 3 DCE/DTE switch (see Figure 2, below). If the device asynchronous data rates to 115.2 kbps, the Model 1010B derives the connected to the Model 1010B is a modem or multiplexer (or is wired necessary power for operation from the data and control voltages on like one), set the switch to "DTE."...
-
Page 4: Connection To The Twisted Pair Interface
The table below shows jumper settings, including factory defaults. ready to connect the Model 1010B to your system. This section tells you how to properly connect the Model 1010B to the twisted pair and Important: When using the Patton Model 1010B with an older RS-232 interfaces, and how to operate the Model 1010B. - Page 5 If your application requires you to connect two pairs of bare wires to the Model 1010B, you will need to open the case to access the note of which color is positive, and which color is negative.
- Page 6 Model the strain relief assembly into the slot in the bottom half of the 1010B. modem case and set it into the recess in the case. Refer to the diagram below to confirm that you have correctly assembled the device.
- Page 7 Connectors: DB-25 male or female on RS-232 side; (Note: If you must use a cable to connect the Model 1010B to the RJ-11, RJ-45 or terminal block with strain RS-232 device, make sure it is a straight through cable of the shortest relief on line side possible length—we recommend 6 feet or less).
- Page 8 4- (RTS) Request to Send 5- (CTS) Clear to Send 6- (DSR) Data Set Ready 7- (SG) Signal Ground Data Term Ready (DTR) - 20 8- (DCD) Data Carrier Detect 1010B Distance (miles) - Normal Mode Wire Gauge Data Rate 115,200 57,600...