Link4 iGrow 100 Series Installation And User Manual page 48

These values can be changed by selecting Buttons #1 and #2. Wheel can be used to mod-
ify the value
after which the curtain can again be opened.By pressing Button #8 user can to go to this
option. Wheel can be used to increase or decrease the values
iGrow Series 100 Manual
Outside Temp Vent Override
Set Vent Open Limit: This is the
maximum position the vent can be
open when the outside temperature
is below the set temperature limit.
Set Temp Limit: This is the user-
specified temperature value which
triggers the Vent Open Limit when
temperature drops below set value.
The curtains are also a dual channel
device and can only be programmed
starting on an odd channel.
The curtain can be programmed for
the Day and Night mode. By press-
ing Buttons #1, #2 user can to go to
these options.
The duration for the start of each
mode can be set using Set Start/End
Time. User can select this option by
pressing Button #5 and then OK.
Open Close Time: It is the time taken
for the curtain to go from full cov-
ered to full uncovered mode and
vice versa. By pressing Button #3
user can to go to this option.
Light Threshold: In case a light sen-
sor is present , the light threshold
value at which the curtain should
shade/ cover. By pressing Button #6
user can to go to this option.
Reopen Delay Time: the time delay
47