be triggered.
3.1.1.2.1.1.4.3.
This Tab lets to set a wait time before the alarm is triggered. This time can be set from 0
to 99 minutes. The alarm condition must exist during the entire wait time for the alarm
condition to be met. If the temperature drops below the threshold during the wait time,
the clock will be reset to 0.
3.1.1.2.1.2.
3.1.1.2.1.2.1.
3.1.1.2.1.2.1.1.
3.1.1.2.1.2.1.1.1. Voltage
3.1.1.2.1.2.1.1.2. Phase
3.1.1.2.1.2.1.1.3. Amps
3.1.1.2.1.2.1.1.4. Power Factor
3.1.1.2.1.2.1.1.5. Status
3.1.1.2.1.2.1.2.
3.1.1.2.1.2.1.2.1. Voltage
3.1.1.2.1.2.1.2.2. HP / kW / Amps
3.1.1.2.1.2.1.2.3. Motor Efficiency
3.1.1.2.1.2.1.2.4. Operational Load
3.1.1.2.1.2.1.2.5. Status
3.1.1.2.1.2.2.
3.1.1.2.1.2.2.1.
3.1.1.2.1.2.2.2.
3.1.1.2.1.2.3.
3.1.1.2.1.2.3.1.
3.1.1.2.1.2.3.2.
3.1.1.2.1.2.4.
3.1.1.2.1.2.4.1.
3.1.1.2.1.2.4.2.
3.1.1.2.1.2.5.
3.1.1.2.1.2.5.1.
iGrow Series 100 Manual
Set Wait Time
Energy Type
Electricity
Measured
Estimated
Oil
BTUs/h
Status
Gas
BTUs/h
Status
Water
Gallon / min
Status
Other
Units/h
101