Link4 iGrow 100 Series Installation And User Manual page 44

The figure below shows the screen to set up the name of the equipment.
channel (vent/curtain) device, the name of the second channel (the even channel) is the
same as the first (odd) channel.
Under the general/energy type setup the type which is selected is the one surrounded
by parenthesis. The image in the following figure shows that On/Off device is selected.
iGrow Series 100 Manual
Before equipment can be utilized,
the proper equipment type must be
defined.
User can go to Initial setting (press
Button 3) to set the name and type
of the corresponding channel.
An optional, but useful, step is to as-
sign a name to the equipment. This
name will be displayed at the MAIN
status screen. Button #3 can be used
to go set name option.
Back button is be used to delete the
present name i.e., Channel 1. Then,
user can enter the desired name.
This screen is similar to the mobile
phone SMS screen. To select a given
alphabet press the required button
the number of times = the position
of the alphabet in the button. E.g. to
type C press Button #1 three times.
To enter numbers use the wheel.
Note: If the equipment is a dual
Button #1 can be used to go set type
option. There are two types for each
piece of equipment:
General Type: the kind of equip-
ment this output controls. There
are 4 available equipment types (see
below).
Energy Type: the type of energy this
equipment consumes (see 2 screens
below).
43