Link4 iGrow 100 Series Installation And User Manual page 25

stages are engaged and the Cool Setpoint is the high temperature target above which the
cooling stages are invoked.
and goes above the Cool Setpoint + the Stage Separation temperature, the system will go
into Cool 2, and so forth.
24
This brings you to the Basic setpoint
menu system.
Pressing Button #6 allows the user
to modify the Heat setpoint.
User can change the temp using
wheel. Similarly user can change the
cool setpoint by pressing on Button
#7
The Heat Setpoint is the low temper-
ature target below which the heat
Pressing Set Time (Button #7)and
then Set DAY Start Time (Button #2)
will allow the start time for the Day
Time Setpoint to be set.
The menu wheel can be used to in-
crease or decrease each highlighted
value
Note that there is only one start time
indicated, since the night and DIF
setpoint has not been programmed
yet.
The Stage Separation is the tempera-
ture spacing between the stages.
Show more options (Button #8) will
let the user go to advanced settings.
Button #5 can be used to set set
stage width. Wheel can be used to
change temperature spacing
For example, when the temperature
in the zone goes above the cool set-
point, the system will go into Cool 1.
If the temperature continues to rise
iGrow Series 100 Manual