Port Setup - ZyXEL Communications XGS-4728F User Manual

Table 14 Basic Setting > IP Setup (continued)
LABEL
IP Subnet
Mask
VID
Delete
Cancel

8.7 Port Setup

Use this screen to configure Switch port settings.Click Basic Setting > Port
Setup in the navigation panel to display the configuration screen.
Figure 43 Basic Setting > Port Setup
The following table describes the labels in this screen.
Table 15 Basic Setting > Port Setup
LABEL
Port
*
Active
XGS-4728F User's Guide
DESCRIPTION
This field displays the subnet mask of the Switch in the IP domain.
This field displays the VLAN identification number of the IP domain on the
Switch.
Click Delete to remove the selected entry from the summary table.
Note: Deleting all IP subnets locks you out of the Switch.
Click Cancel to clear the Delete check boxes.
DESCRIPTION
This is the port index number.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports.
Use this row first to set the common settings and then make adjustments
on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you
make them.
Select this check box to enable a port. The factory default for all ports is
enabled. A port must be enabled for data transmission to occur.
Chapter 8 Basic Setting
89