Tunnel Protocol Attribute - ZyXEL Communications XGS-4728F User Manual

Table 71 Supported VSAs
FUNCTION
Egress Bandwidth
Assignment
Privilege
Assignment

25.2.5 Tunnel Protocol Attribute

You can configure tunnel protocol attributes on the RADIUS server (refer to your
RADIUS server documentation) to assign a port on the Switch to a VLAN based on
IEEE 802.1x authentication. The port VLAN settings are fixed and untagged. This
will also set the port's VID. The following table describes the values you need to
configure. Note that these atrributes only work when you enable authorization
(see Section 25.2.3 on page
Table 72 Supported Tunnel Protocol Attribute
FUNCTION
VLAN Assignment
XGS-4728F User's Guide
ATTRIBUTE
Vendor-Id = 890
Vendor-Type = 2
Vendor-data = egress rate (Kbps in decimal format)
Vendor-ID = 890
Vendor-Type = 3
Vendor-Data = "shell:priv-lvl=N"
or
(CISCO)
Vendor-ID = 9
Vendor-Type = 1 (CISCO-AVPAIR)
Vendor-Data = "shell:priv-lvl=N"
where is a privilege level (from 0 to 14).
N
Note: If you set the privilege level of a login account differently
on the RADIUS server(s) and the Switch, the user is
assigned a privilege level from the database (RADIUS or
local) the Switch uses first for user authentication.
221).
ATTRIBUTE
Tunnel-Type = VLAN(13)
Tunnel-Medium-Type = 802(6)
Tunnel-Private-Group-ID =
Note: You must also create a VLAN with the specified VID on
the Switch.
Note: The bolded values in this table are fixed values as defined
in RFC 3580.
Chapter 25 AAA
VLAN ID
225