Tacacs+ Server Setup - ZyXEL Communications XGS-4728F User Manual

Table 68 Advanced Application > AAA > RADIUS Server Setup (continued)
LABEL
Shared Secret
Delete
Apply
Cancel

25.2.2 TACACS+ Server Setup

Use this screen to configure your TACACS+ server settings. See
page 216 for more information on TACACS+ servers. Click on the TACACS+
Server Setup link in the Authentication and Accounting screen to view the
screen as shown.
Figure 117 Advanced Application > AAA > TACACS+ Server Setup
XGS-4728F User's Guide
DESCRIPTION
Specify a password (up to 32 alphanumeric characters) as the key to be
shared between the external RADIUS accounting server and the Switch.
This key is not sent over the network. This key must be the same on the
external RADIUS accounting server and the Switch.
Check this box if you want to remove an existing RADIUS accounting
server entry from the Switch. This entry is deleted when you click Apply.
Click Apply to save your changes to the Switch's run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Chapter 25 AAA
Section 25.1.2 on
219