ZyXEL Communications XGS-4728F User Manual page 182

Chapter 21 Policy Rule
The following table describes the labels in this screen.
Table 52 Advanced Application > Policy Rule
LABEL
Active
Name
Classifier(s)
Parameters
Set the fields below for this policy. You only have to set the field(s) that is related to the
action(s) you configure in the Action field.
General
Egress
Port
Priority
DSCP
TOS
Metering
Bandwidth Specify the bandwidth in kilobit per second (Kbps). Enter a number
Out-of-
Profile
DSCP
Action
Specify the action(s) the Switch takes on the associated classified traffic flow.
Forwarding
Priority
182
DESCRIPTION
Select this option to enable the policy.
Enter a descriptive name for identification purposes.
This field displays the active classifier(s) you configure in the Classifier
screen.
Select the classifier(s) to which this policy rule applies. To select more
than one classifier, press [SHIFT] and select the choices at the same time.
Type the number of an outgoing port.
Specify a priority level.
Specify a DSCP (DiffServ Code Point) number between 0 and 63.
Specify the type of service (TOS) priority level.
You can configure the desired bandwidth available to a traffic flow. Traffic
that exceeds the maximum bandwidth allocated (in cases where the
network is congested) is called out-of-profile traffic.
between 1 and 1000000.
Specify a new DSCP number (between 0 and 63) if you want to replace or
remark the DSCP number for out-of-profile traffic.
Select No change to forward the packets.
Select Discard the packet to drop the packets.
Select Do not drop the matching frame previously marked for
dropping to retain the frames that were marked to be dropped before.
Select No change to keep the priority setting of the frames.
Select Set the packet's 802.1 priority to replace the packet's 802.1
priority field with the value you set in the Priority field.
Select Send the packet to priority queue to put the packets in the
designated queue.
Select Replace the 802.1 priority field with the IP TOS value to
replace the packet's 802.1 priority field with the value you set in the TOS
field.
XGS-4728F User's Guide