ZyXEL Communications XGS-4728F User Manual page 74

Chapter 7 System Status and Port Statistics
The following table describes the labels in this screen.
Table 9 Status
LABEL
Port
Name
Link
State
LACP
TxPkts
RxPkts
Errors
Tx KB/s
Rx KB/s
Up Time
Clear Counter
74
DESCRIPTION
This identifies the Ethernet port. Click a port number to display the Port
Details screen (refer to
This is the name you assigned to this port in the Basic Setting > Port
Setup screen.
This field displays the speed (either 10M for 10 Mbps, 100M for 100
Mbps, 1000M for 1000 Mbps, and 10G for 10 Gbps) and the duplex (F
for full duplex or H for half). It also shows the cable type (Copper or
Fiber) for the combo ports.
If STP (Spanning Tree Protocol) is enabled, this field displays the STP
state of the port. (see Section 13.1.3 on page 127
If STP is disabled, this field displays FORWARDING if the link is up,
otherwise, it displays STOP.
This fields displays whether LACP (Link Aggregation Control Protocol) has
been enabled on the port.
This field shows the number of transmitted frames on this port.
This field shows the number of received frames on this port.
This field shows the number of received errors on this port.
This field shows the transmission speed of data sent on this port in
kilobytes per second.
This field shows the transmission speed of data received on this port in
kilobytes per second.
This field shows the total amount of time in hours, minutes and seconds
the port has been up.
Type a port number, select Port and then click Clear Counter to erase
the recorded statistical information for that port, or select Any to clear
statistics for all ports.
Figure 38 on page 75).
for more information).
XGS-4728F User's Guide