Layer 2 Protocol Tunneling Mode - ZyXEL Communications XGS-4728F User Manual

Chapter 29 Layer 2 Protocol Tunneling
2 for PAgP (Port Aggregation Protocol), LACP or UDLD (UniDirectional Link
Detection).
Figure 142 L2PT Network Example
A
STP

29.1.1 Layer 2 Protocol Tunneling Mode

Each port can have two layer 2 protocol tunneling modes, Access and Tunnel.
• The Access port is an ingress port on the service provider's edge device (1 or 2
in Figure 142 on page
Incoming layer 2 protocol packets received on an access port are encapsulated
and forwarded to the tunnel ports.
• The Tunnel port is an egress port at the edge of the service provider's network
and connected to another service provider's switch. Incoming encapsulated
layer 2 protocol packets received on a tunnel port are decapsulated and sent to
an access port.
264
STP
1
Service Provider's
Network
264) and connected to a customer switch (A or B).
B
STP
2
C
XGS-4728F User's Guide
D