JRC JSS-2150 Instruction Manual page 189

6 .
6 .
6 .
Return the roll paper cover to its original
position, and place the roll support cover
as shown in the figure at right.
7 .
7 .
7 .
Close the printer cover, return the roll
paper stand to its original position, and
tighten the fixing screws.
To perform a print test, turn the printer on with the LF key held down.
Note
To end the print test, turn the printer off.
■
Replacing the ink ribbon
1 .
1 .
1 .
Turn the printer on, and following the same
procedure as that in the previous section,
open the printer cover, lift up the ink ribbon
cartridge by holding the projection on the
cartridge, and lift the cartridge up to
remove it.
2 .
2 .
2 .
Using the knob on the new cartridge to make
the ribbon taut, manually move the print
head to the left edge, and attach the ribbon
so that it is between the ribbon mask and
print head.
3 .
3 .
3 .
Close the printer cover, return the roll paper
stand to its original position, and tighten the
fixing screws.
Note
For other details, check the NKG-800 Installation Guide. The printer's operation
mode can be set by the DIP switches. However, leave the DIP switch settings at
their factory defaults (all off) when using the printer connected to the equipment.
■
Options Operation
Roll support
cover
Roll paper
cover
Projection
Ink ribbon
cartridge
Print head
Knob
Ink ribbon
cartridge
10-7