Turning Off The Power/ Putting Into Sleep Mode - JRC JSS-2150 Instruction Manual

Operation
4.2.2

Turning off the power/ Putting into sleep mode

When completely turning off the power to the equipment, turn off the breaker
on the transceiver
■ ■
Procedure
1 .
1 .
1 .
PW R
Press the
C O N T
simultaneously.
After that, the power-off process is activated
according to the controllers' status.
When using only one controller
Select the desired item below on the
popup screen shown at right
⋅
[OK]:
⋅
[Cancel]: Returns to the previous
When using two controllers
On a controller with access rights, select
the desired item below on the popup
screen shown at right
⋅
[EQP]:
⋅
[CTRL]:
⋅
[Cancel]: Returns to the previous screen.
On a controller without access rights,
select the desired item below on the
displayed popup screen at right
⋅
[OK]:
⋅
[Cancel]: Returns to the previous
In sleep mode, the equipment changes to the following statuses.
Note
⋅
⋅
⋅
Turn off both the AC and DC breakers if turning off the power at an external
NBD-2150 AC/DC Power supply.
4-6
CAUTION
key and DIM key
Turns off the power. (Puts into
sleep (energy saving) mode.)
screen.
Turns off the power. (Puts into
sleep (energy saving) mode.)
Puts the controller into sleep
mode and gives access rights
to another controller.
Puts one controller into sleep
mode.
screen.
If all the equipment goes to sleep, the ALM lamp lights green to indicate
the DSC watch keeping receiver is on and operating.
The POWER lamp blinks in the data terminal.
If a distress or urgent
automatically turns on and sounds an alarm.
DSC message is received, the equipment