Own Ship Position And Time Settings - JRC JSS-2150 Instruction Manual

5.2 Own ship position and time settings

Normally, the ship's position and the time are updated automatically if importing GPS information.
But, if necessary, input these parameters manually as follows.
The time in the 7.2 POS/TIME menu means the time when the position
information is valid, and is different from the present time mentioned in the
7.1 Date & time menu.
■ ■
Procedure
1 .
1 .
1 .
Press the
MENU
hierarchical menus, select 7.2
POS/TIME.
2 .
2 .
2 .
To input your own ship's position, press
ENT.
Select the position quadrant with the jog dial,
and press ENT. Then input the latitude and
longitude with the numeric keypad or jog dial,
and press ENT.
3 .
3 .
3 .
When completing the input of the ship's
position, the cursor moves to the time
column of the
2. UTC of position.
Input the hours and minutes with the
numeric keypad or jog dial, and press
ENT.
Just after inputting the position, the
present time is input to this column
automatically.
To close this menu after completing the
setting, press the
- If the position and the time information are received from an external device,
Note
such as a GPS, the manually entered data is overwritten automatically.
- If the position and the time information are not received, from a GPS or other
device, within 10 minutes after powering on, or after 10 minutes has elapsed
since input was interrupted, the similar screen appears with an alarm
automatically. Further, regardless of either manual or automatic input, if the
position and the time are not updated within 4 hours since the last entry, the
screen with the alarm will appear repeatedly.
CAUTION
key, and through
CANCEL key.
Settings & Registrations
7.2)POS/TIME
1.Own position:NE
89ﾟ59.1234'N
179ﾟ59.1234'E
2.UTC of position:
23:59
0.Back
7.2)POS/TIME
1.Own position:NE
89ﾟ59.1234'N
179ﾟ59.1234'E
2.UTC of position:
23:59
0.Back
7.2)POS/TIME
1.Own position:NE
89ﾟ59.1234'N
179ﾟ59.1234'E
2.UTC of position:
23:59
0.Back
5-3