JRC JSS-2150 Instruction Manual page 156

Settings & Registrations
5 .
5 .
5 .
When the cursor is located on Set, press Enter key to set the value and close the
popup screen.
6 .
6 .
6 .
After completing the every input, move the cursor to Set and press Enter key to save
and finish the registration.
- When selecting the Initialize with the cursor and pressing Enter key, the every
Note
accessible item is reset to the factory default setting.
- The content of each item and the factory default setting values are as follows.
Item
ARQ/FEC 4- or 5-digit Self-ID
GFEC 4- or 5-digit Self-ID
ARQ/FEC 9-digit Self-ID
GFEC 9-digit Self-ID
Answerback
Max. FEC error rate
Max. automatic call series
Collective FEC receiving
Time duration for AUTO
Restart
Finite start/restart
Transmitter pre-key time
5-18
Setting contents
Registers the SELCAL number.
※ 4-digit is for the coast station.
Registers the group ID.
※ 4-digit is for the coast station
9-digit SELCAL number for
reference.
Registers the 9-digit group ID.
Registers the answerback code
used with WRU and Hereis.
Sets the permissible error rate that
occurs during CFEC receiving.
Sets times to retry calling a station
if failed to call the station using the
CALL function.
Sets ON/OFF of the CFEC or SFEC
receiving.
Sets the interval time until retrying
if failed to call a coast station using
the AUTOTELEX function.
Sets ON/OFF of the
function if disconnected
communication in ARQ mode.
Sets ON/OFF of the limit of the
ARQ call times, which is 128 times
for phasing and 32
rephasing.
Sets a period between key on and
starting the signal output.
Initial
value
-----
-----
-----
-----
-----
30 %
2
ON
10 min
rephasing
the ON
ON
times for
10 ms
Remarks
When setting this item,
contact our company or
agency.
Common with the DSC
When setting this item,
contact our company or
agency.
Optional
Optional