Setting Connections For Options - JRC JSS-2150 Instruction Manual

Settings & Registrations

5.6 Setting connections for options

When setting connections between the controller and optional devices, such as a printer,
configure the conditions as appropriate according to the device type, as follows.
■ ■
Procedure
1 .
1 .
1 .
Press the
MENU
hierarchical menus, select 7.6 Option.
2 .
2 .
2 .
Move the cursor to the desired item, and
press ENT.
Move the cursor to the right. Then select the
condition as appropriate and press ENT.
- The content and the selectable conditions of each item are as follows.
Note
Item Name
Connection
Data out
Baudrate
Flow control
Print direction
- When connecting a serial printer (e.g. NKG-91), set the items as follows:
1.Connection
2.Data out
3.Baudrate
4.Flow control
5.Print direction
- When connecting the NKG-800 printer, set the items as follows:
1.Connection
2.Data out
- If no option is connected, select None/CMD at the Connection.
Note)
- When connecting the data terminal to the controller for the telex communication,
set Connection item to DTE. Note that restart the system just after this setting.
Moreover, Baudrate, Flow control and Print direction become unchangeable in
this case.
5-12
key, and through
Content
Connection status and printer type
Printing method for DSC messages
Transmission speed to printer
Handshake setting with printer
Printing sequence of lines
:Serial PRN
:Auto
:4.8k
:Hard
:Invert (NKG-91)/Upright (DPU-414)
:NKG-800
:Auto
When None/CMD is set, connect nothing to the serial port.
7.6)Option
1.Connection :None/CMD
2.Data out :---
3.Baudrate :---
4.Flow control :---
5.Print direction :---
0.Back
7.6)Option
1.Connection :None/CMD
2.Data out :---
3.Baudrate :---
4.Flow control :---
5.Print direction :---
0.Back
Selectable conditions
( : F a c t o r y d e f a u l t )
None/CMD/ Serial PRN/
NKG-800/ DTE
---/ Auto/ Manual
---/ 4.8k/ 9.6k/ 38.4k/ 57.6kbps
---/ None/ Hard
---/ Upright/ Invert