Telex Communication Screen - JRC JSS-2150 Instruction Manual

Names and Functions
2.4.6

Telex communication screen

[ T L X ] T x = 2 1 7 4 . 5 k H z / R x = 2 1 7 4 . 5 k H z
F r e e s i g .
1
M e s s a g e s t a r t . . .
2
3
F 2 W R U | F 3 H e r e i s | F 4 T M S | F 5 O v e r | F 8 F . S e n d | F 1 0 S t o p
1. Indicates the operating condition of the
telex communication from the left of each
segment as follows.
1） In the autotelex mode, when the free
channel signal of the coast station is
detected, indicates the "Free Sig".
2） Indicates the communication mode
(ARQ/CFEC/SFEC).
※ Indicates "ST-BY" in the standby
condition.
3） Indicates "Calling"
station, and "Called" at the slave
station.
4） Indicates "Send" at the information
sending station, and "Receive" at the
information receiving station.
5） Indicates "Phasing" while calling and
connecting
channel and
reconnecting the channel after the
channel is disconnected due to the
channel condition in ARQ mode.
6） Indicates "Repeat" in ARQ mode if
requested to send the each block or
the control signal again.
7） Indicates "Traf"
receiving information and "RQ" while
sending or receiving RQ signal.
2-8
T E L E X T e r m i n a l W i n d o w
A R Q C a l l i n g
A R Q
at the master
the communication
"Rephasing" while
while sending or
U S B
R e p h a s i n g R e p e a t
S e n d
2. Indicates the telex message or the name
of the executed function key.
3. Indicates the usable function keys guide.
Each meaning is as follows.
F2 WRU
F3 Hereis ： Sends the answerback
F4 TMS
F5 Over
F6 POLL
※ It is available only when the
corresponding station is using the
modem made of our company.
F8 F.Send ： Sends a message file.
F10 Stop
T r a f
： Requests the answer-
back code to
corresponding station.
code of own station.
： Sends the date and the
time information.
： Exchange the sending
and the receiving
condition.
： Acquires the sending
right if the correspond-
ing station (sending)
tries to finish
communication in ARQ
mode.
： Finishes the telex
communication.
the
the