Selecting Tx Meters - JRC JSS-2150 Instruction Manual

Settings & Registrations
5.3.4

Selecting Tx meters

The meter displayed in the status display indicates the strength of the received signal (S meter).
However, it can also indicate one of Tx power, antenna current, PA voltage, PA current or key
information during transmission.
■ ■
Procedure
1 .
1 .
1 .
Press the
MENU
hierarchical menus, select 7.3 My
controller.
The screen as shown at right is displayed.
2 .
2 .
2 .
Move the cursor to 4. Tx meter with the
numeric keypad or jog dial.
3 .
3 .
3 .
Press ENT, and select the meter type
with the jog dial.
The selectable meters are as follows:
PWR .... Tx power
Ia ........ Antenna current
Vc ....... PA voltage
Ic ........ PA current
Key.......Key information*
* When keying during the ARQ
communication, the Key is indicated
regardless of this setting.
4 .
4 .
4 .
Press ENT to confirm the selection.
The setting is complete.
5-6
key, and through
7.3)My controller
1.LCD adjustment
2.Sound
3.User key assign
4.Tx meter :PWR
5.Data transfer
0.Back
7.3)My controller
1.LCD adjustment
2.Sound
3.User key assign
4.Tx meter :PWR
5.Data transfer
0.Back
7.3)My controller
1.LCD adjustment
2.Sound
3.User key assign
4.Tx meter :Ia
5.Data transfer
0.Back
7.3)My controller
1.LCD adjustment
2.Sound
3.User key assign
4.Tx meter :Ia
5.Data transfer
0.Back