Removing The Cover And Bezel; Installing A Pci Or Pci-X Adapter - IBM xSeries 365 Option Installation Manual

Removing the cover and bezel

Complete the following steps to remove the cover and bezel:
1. Read the safety information beginning on page v, and "Installation guidelines"
2. If you are installing or replacing a non-hot-swap component, turn off the server
3. Slide the server out of the rack until the slide rails lock into place.
4. Lift the cover-release latch. The cover slides to the rear approximately 13 mm
5. Press on the bezel retention tabs at the top edge of the bezel, and pull the top
6. Lift the bezel up to release the two tabs at the bottom edge of the bezel.

Installing a PCI or PCI-X adapter

Attention:
hot-pluggable. Turn off the server before removing or replacing the Remote
Supervisor Adapter II.
The following notes describe the types of adapters that your server supports and
other information that you must consider when installing a PCI or PCI-X adapter:
v The server supports 3.3 V and universal PCI and PCI-X adapters; it does not
v The following illustration shows the location and bus speeds of the PCI-X
on page 11.
and all attached peripheral devices. Disconnect all power cords; then,
disconnect all external signal cables from the server.
Top cover
Bezel
xS eri
es
(0.5 inch). Lift the cover off the server.
Attention: For proper cooling and airflow, replace the top cover before
turning on the server. Operating the server for more than 2 minutes with the top
cover removed might damage server components.
of the bezel slightly away from the server.
The Remote Supervisor Adapter II, which is in PCI slot 1, is not
support 5.0-V-only adapters.
expansion slots on the I/O board.
36 5
Cover release
latch
Chapter 2. Installing options
13