Replacing The Battery - IBM xSeries 365 Option Installation Manual

4. If you are replacing a failed power supply, remove the failed power supply from
5. Raise the handle on the new power supply to the open position.
6. Place the new power supply into the power bay in the chassis and fully close
7. Connect one end of the power cord for the new power supply into the connector
8. Make sure that the ac power LED on the rear of the power supply and the ac
9. Continue with "Completing the installation" on page 35.

Replacing the battery

The following notes describe information that you must consider when replacing the
battery in the server.
v When replacing the battery, you must replace it with a lithium battery of the same
v To order replacement batteries, call 1-800-772-2227 within the United States, and
v After you replace the battery, you must reconfigure the system and reset the
v To avoid possible danger, read and follow the following safety statement.
Statement 2:
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has
a module containing a lithium battery, replace it only with the same module
type made by the same manufacturer. The battery contains lithium and can
explode if not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
the bay.
a. Disconnect the power cord from the connector on the back of the failed
power supply.
b. Press the locking latch on the power supply handle and raise the power
supply handle to the open position.
c. Lift the failed power supply out of the bay.
the locking handle.
on the back of the power supply; route the power cord through the
cable-management arm and connect the other end of the power cord into a
properly grounded electrical outlet.
power LED on the top of the power supply are lit, indicating that the power
supply is operating correctly. If the server is turned on, make sure that the dc
power LED on the top of the power supply is lit also.
type from the same manufacturer.
1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and
Canada, call your IBM reseller or IBM marketing representative.
system date and time.
Chapter 2. Installing options
31