Connecting The Cables - IBM xSeries 365 Option Installation Manual

2. Move the cover-release latch to the open (up) position.
3. Insert the tabs on the cover into the matching slots in the server chassis.
4. Press down on the cover-release latch. The cover-release latch slides the cover
5. Insert the tabs on the bottom of the bezel into the matching holes on the server
6. Push the top of the bezel toward the server until the two tabs at the top of the
7. Slide the server fully into the rack cabinet.
8. If you disconnected any power cords or external cables from the server,
Note: Depending on the options that you installed, you might need to run the

Connecting the cables

This section describes how to connect cables to the server, with particular
instructions for the RXE Expansion Port, RXE Management Port, and Ethernet
connectors. When instructed, see the applicable documentation for more details.
36
IBM xSeries 365 Type 8861 and 8862: Option Installation Guide
Top cover
Bezel
xS
eri
es 36
5
forward into position and locks the cover in place.
chassis.
sides of the bezel snap into place. You might need to press the bezel side
latches as you perform this step.
reconnect the external cables first. If you are adding any new peripheral devices
(see "Connecting the cables" for details), you can connect the external cables
for those devices. Then, connect the power cords to properly grounded
electrical outlets.
Configuration/Setup Utility program to update the server configuration. See
the User's Guide for more information.
Cover release
latch