Installation; Configuration; Phone Keypad Set - ATCOM AT-320 H323 User Manual

AT-320 H323 Phone User Manual (V1.39)

Installation:

1 Connect handset to base: insert handset cord into handset cord jack at the left side
of the base.
2 Connect IP phone to Internet: plug the RJ-45 Ethernet cable into the Ethernet Jack.
Plug the other end of the cable into HUB. Refer to Fig 2.2 please.
Power on IP phone: p
other end of the power cord adapter into the appropriate wall outlet.

Configuration

Four different ways can be used to configure AT-320 H323 phone: phone
keypad, web browser, Telnet commands and PalmTool configuration tool on
computer.
Phone Keypad setup
● Function Keys Introduction: When using keypad and LCD to configure the
settings of IP phone, following keys will be used:
Keys
LOCIP/SET Enter setting mode
Turn
VOL
backward
Modify values
NUMBERS
● Enter into settings
isn't 0,the original password is 1234; If the debug is O, please use super password
1234567878)
LCD
confirm. You successfully enter into settings.
lug the power cord adapter into the Power Jack. Then plug the
Function
SPEAKER/OK
over menu
REDIAL/EXIT
Please Inputting the phone password on the keypad (If the debug
#
then press # for a while until there is Password stated on the
Password
, Please input the phone password again and press
Keys
Enter submenu; confirm change
Turn over menu forward; move
VOL -
cursor backward
Exit current menu; exit setting mode
Function
to
5