Auxiliary Input - Jensen JiTS-300i User Manual

This unit provides an auxiliary audio signal input jack for connecting external audio
devices like MP3 players, CD players and listen to them through the speakers of this
unit.
1. Use an audio cable (not included) with one 3.5 mm stereo plug on each end of the
cable.
2. Plug one end into the LINE IN (Aux-in) jack on the rear of main unit and the other end
of the cable into the Line-out Jack or Headphone Jack of your external audio device.
3. Turn on the external audio device.
4. To select auxiliary audio input, press the SOURCE button to select LINE IN mode,
"LINE" message shows on LCD display.
5. The volume level can now be controlled through the main unit. Operate all other
functions on the auxiliary device as usual.
NOTE:
If you connect this unit to the Line-Out Jack of your external device then you only
need to adjust the volume control of this unit. If you connected the Headphone Jack
of your external device then you may need to adjust both the volume control of your
external device and the volume control of this unit to find the most desirable volume
setting.
Press the POWER button to turning off the unit when you finish listening. Don't
forget to switch off the power of your external device as well.
If the system does not respond or exhibits erratic or intermittent operation, you may
have experienced an electrostatic discharge (ESD) or a power surge that triggered the
internal microcontroller to shut down automatically. If this occurs, you can use a
straightened paper clip, toothpick or similar objects to press the RESET button located
at the rear of the unit to restore the unit to its factory preset condition.
CAUTION: DO NOT USE SHARP, POINTED OBJECT TO PRESS THE RESET
BUTTON. IT MAY DAMAGE THE RESET SWITCH INSIDE THE UNIT.
Please note that all personal settings including current time will be cleared and will
need to be reset, so be sure to set up the clock again according to previous sections
above.
Note: In very rare instances, such as an electrostatic discharge on a dry cold winter day,
if the unit still fails to reset after pressing the RESET Button, you should unplug it
from the AC power source for at least 3 minutes. After 3 minutes, plug the unit
back in and press the RESET button again.

AUXILIARY INPUT

RESETTING
10