To Enable The Timer - Rigol DP800A Series User Manual

RIGOL
To Save and Read the Timer File
You can store the timer parameters edited manually or using the templet in internal
or external memory and recall them when required.
1. Save
After editing the timer parameters, press Save to enter the store and recall
interface. The file type is fixed at "*.rtf" and please save the file according to the
introduction in "Save".
2. Read
Press Read to enter the store and recall interface. The file type is fixed at "*.rtf"
and please read the desired file according to the introduction in "Read". Users
can edit the timer file read.

To Enable the Timer

After setting the timer parameters, return to the timer and delayer interface (as
shown in Figure 2-1). Press Timer to enable the timing output. The timing output
interface is as shown in the figure below.
Tip
Enabling the timer will change the output value of the channel; make sure

that the change in the output value will not affect the device connected to
the power supply before enabling the timer.
The timing output is valid only when both the timer and the channel output

are turned on.
When the timer is enabled, the timer parameters cannot be modified and

Delayer is grayed out and disabled.
2-26
Figure 2-3 Timing Output Interface
Chapter 2 Front Panel Operations
DP800A User's Guide