RIGOL
Remote Control via GPIB
1. Connect the device
Use the USB to GPIB interface converter to extend a GPIB interface for the
power supply. Then, connect the power supply to your PC using a GPIB cable.
2. Install the driver of GPIB card
Install the driver of the GPIB card which has been connected to the PC correctly.
3. Set the GPIB address
Set the GPIB address of the power supply according to the description in "To
Set the GPIB Address".
4. Search device resource
Start up Ultra Sigma and click
the figure (a). Click
instrument resource connected to the PC. The instrument resource found will be
displayed at the right side of the window as shown in figure (b). Click
to add the instruemnt resource.
3-8
to open the window as shown in
and the software will search for the GPIB
(a)
(b)
Chapter 3 Remote Control
DP800A User's Guide