To Set The Timer Parameters - Rigol DP800A Series User Manual

Chapter 2 Front Panel Operations
Tip
The timer function and delayer function are mutually exclusive. When the timer is
enabled, Delayer is grayed out and disabled; when the delayer is enabled, Timer
is grayed out and disabled.

To Set the Timer Parameters

Press Timer  Timer Set to enter the timer parameter setting interface as shown
in the figure below. The channel currently selected is displayed in the status bar.
Press the channel selection keys at the front panel to switch the channel currently
selected. This interface provides timer parameter preview; users can view the values
on the current page of the timer parameter list (the horizontal axis represents time
and the vertical axis represents voltage and current).
Timer Parameter Preview
You can set the timer parameters in the timer parameter setting interface following
the steps below.
1. To Set the Number of Output Groups
2. To Set the Number of Cycles
3. To Set the End State
4. To Edit the Timer Parameters
5. To Save and Read the Timer File
DP800A User's Guide
Channel Currently Selected
Figure 2-2 Timer Parameter Setting Interface
Timer Parameter List
RIGOL
2-17