Using The Gun Regulator Rmt 10; Regulating The Wire Feed Speed And Welding Power; Selecting The Selecto Channel - Kemppi 25 Operating Manual

5.

using THe gun regulaTOr rMT 10

Depending on the panel used in the Promig (or Feed) wire feeder, the gun
regulator RMT 10 will enable you to regulate wire feed speed in MIG welding
as well as the welding power of synergic MIG or pulsed MIG welding. You can
also select preprogrammed welding parameters from Selecto channels 1 – 5
according to your wishes. Selecting and regulating signals of Selecto channel
are transmitted along the start lines of the gun through a Euro adapter.
The gun regulator RMT 10 works only with the Promig and Feed wire feeders.
5.1 regulaTing THe wire Feed sPeed and welding
POwer
The means to regulate the wire feed speed for MIG welding and regulation
of welding power for synergic MIG or pulsed MIG welding as well as other
relevant regulations, fine adjustment and selections are described in the
operation instructions for Promig and Feed wire feeder units.
5.2

seleCTing THe seleCTO CHannel

When you are using a wire feeder fitted with a panel with Selecto mode, you can
also select the channels 1
10. The use of the Selecto mode is described in the operation instructions for the
Promig.
–
Positions 1
–
channels 1
position of the potentiometer and to feel channel positions when turning the
potentiometer, you should release the spring-loaded bearing of the RMT 10. On
the outer edge of the potentiometer there are grooves corresponding to Selecto
–
channels 1
–
5 from the PMT gun by using the gun regulator RMT
5 of the potentiometer on the RMT 10 correspond to the Selecto
5 (see sticker on the potentiometer). In order to find correct
5 into which the bearing slides.
EN
9