Mounting The Gun Regulator Rmt 10 - Kemppi 25 Operating Manual

4.

MOunTing THe gun regulaTOr rMT 10

In the handle of the PMT gun there is a place for the gun regulator RMT 10
(6185475), which is available as an accessory. This regulator enables you to
ragulate the welding power of synergic MIG or pulsed MIG welding with the
Promig and Feed, or select preprogrammed welding parameters according to
your wishes.
In the delivery state there is a cover plate in place of the gun regulator.
EN
• Release the fastening screw of the cover plate.
• Release the cover plate from the handle by pushing it out on its guides.
• Push the gun regulator RMT 10 onto the guides, but not completely
• Tighten the screw.
8
RMT 10
Under the rear end of the cover plate you will now see a connector to
which the gun regulator connects. Make sure the regulator RMT 10, its
connectors and the connectors of the gun are free of metal powder, dirt,
etc. Clean carefully if necessary.
to the end. Make sure that the connector on the handle side is in the
correct position and that the connectors are correctly connected to each
other. Push the regulator carefully to its place.