Table of Contents
Advertisement
Quick Links
XX140-00-01
MODEL SVFT-UWM
UNIVERSAL WALL MOUNT FOR THE
SURVEYORVFT CAMERA DOME
SYSTEM
Copyright © 2004 Vicon Industries Inc. All rights reserved.
Product specifications subject to change without notice.
Vicon and its logo are registered trademarks of Vicon Industries Inc.
VICON INDUSTRIES INC., 89 ARKAY DRIVE, HAUPPAUGE, NEW YORK 11788
TEL: 631-952-CCTV (2288) FAX: 631-951-CCTV (2288) TOLL FREE: 800-645-9116
24-Hour Technical Support: 800-34-VICON (800-348-4266)
UK: 44/(0) 1489-566300 WEB: www.vicon-cctv.com
Vicon part number 8009-8140-00-01
Section 3 Rev 1104
Advertisement
Table of Contents
Related Manuals for Vicon SVFT-UWM
Summary of Contents for Vicon SVFT-UWM
- Page 1 Copyright © 2004 Vicon Industries Inc. All rights reserved. Product specifications subject to change without notice. Vicon and its logo are registered trademarks of Vicon Industries Inc. VICON INDUSTRIES INC., 89 ARKAY DRIVE, HAUPPAUGE, NEW YORK 11788 TEL: 631-952-CCTV (2288) FAX: 631-951-CCTV (2288) TOLL FREE: 800-645-9116 24-Hour Technical Support: 800-34-VICON (800-348-4266) UK: 44/(0) 1489-566300 WEB: www.vicon-cctv.com...
-
Page 5: Unpacking And Inspection
National Electrical Code ANSI/NFPA 70, state, and local electrical codes. Read these instructions thoroughly before beginning an installation. This mount has only been evaluated for use with UL Listed Vicon Camera Domes. Refer to the Listed Camera Dome’s manual for compatibility. -
Page 6: Installation Procedure
7. Line up the mounting holes and attach the mount to the supporting structure. 8. Carefully seal the perimeter edge of the mount after installation. Note: Pay particular attention that all gaps are sealed if the SVFT-UWM is mounted to an irregular surface, such as a brick facade. - Page 7 9. Install the dome housing onto the mount following the instructions in the manual for the camera dome system. 10. For high vandalism areas, lock the dome with the soft tip set screw supplied. Installation • 3 XX140-00-01 Rev 1104 SVFT-UWM Universal Wall Mount...
-
Page 8: Technical Information
ENVIRONMENTAL (Not evaluated by UL) Storage Temperature Range: -40° to 150° F (-40° to 60° C). Storage Humidity Range: 0 to 90% relative, noncondensing. Figure 1 Maximum Outline Dimensions 4 • Technical Information XX140-00-01 Rev 1104 SVFT-UWM Universal Wall Mount... -
Page 9: Shipping Instructions
Shipping Instructions Use the following procedure when returning a unit to the factory: 1. Call or write Vicon for a Return Authorization (R.A.) at one of the locations listed below. Record the name of the Vicon employee who issued the R.A. - Page 10 Software supplied either separately or in hardware is furnished on an “As Is” basis. Vicon does not warrant that such software shall be error (bug) free. Software support via telephone, if provided at no cost, may be discontinued at any time without notice at Vicon’s sole discretion.
- Page 11 Notes Vicon Standard Equipment Warranty • 7 XX140-00-01 Rev 1104 SVFT-UWM Universal Wall Mount...
- Page 12 Vicon Industries Inc. Corporate Headquarters 89 Arkay Drive Hauppauge, New York 11788 631-952-CCTV (2288) 800-645-9116 Fax: 631-951-CCTV (2288) Vicon Europe Headquarters Brunel Way Fareham, PO15 5TX United Kingdom +44 (0) 1489 566300 Fax: +44 (0) 1489 566322 Brussels Office Planet II - Unit E...
Need help?
Do you have a question about the SVFT-UWM and is the answer not in the manual?
Questions and answers