Lighting Instruction - Member's Mark 720-0830F Assembly & Operating Instructions

TO MATCH LIGHT THE SIDE BURNER
Hold a lit extended match near the side burner ports, turn
the control knob counterclockwise to "IGNITE/HI". Move
your hand immediately once the burner is lit. Rotate the
control knob to the desired setting.
Keep a spray bottle of soapy water near the gas
supply valve and check the connections before each
use.
Do not attempt to light the grill if odor of gas is
present. Call for service 1-888-301-0332.
FLAME CHARACTERISTICS
Check for proper burner flame characteristics.
Burner flames should be blue and stable with no yellow
tips, excessive noise, or lifting. If any of these conditions
exist call our customer service line. If the flame is yellow,
it indicates insufficient air. If the flame is noisy and tends
to lift away from the burner, it indicates too much air.
Each burner is adjusted prior to shipment; however,
variations in the local gas supply may make minor
adjustments necessary.
Note: Remove all packaging, including straps, before using the grill
OFF OFF
IGNITE / HIGH IG NITE / HIG H
LOW LOW
Main Burners
IGNITE / HIGH
3
IGNITE / ON
OFF OFF
IG NITE / HIG H IG NITE / HIG H
LOW LO W
OFF
2
1
LOW
2
1
Grill Lighting Instructions
Visually check the burner flames prior to each
use, The flames should look like this picture, if
they do not ,refer to the burner maintenance part
of this manual.
O FF
IG NITE / HI
LO W
Sear Burner
1
Make sure the lid is open.
Push and turn Main Burner knob slowly to
2
IGNITE/HIGH,. Keep knob pressed in until the burner
is lit.
If burner does not light within 5 seconds, turn the knob
3
to OFF and repeat the lighting instruction.
If burner does not light up after step 3, turn the knob to
4
OFF, wait 5 minutes, and repeat the lighting procedure
or light by match.
18
continued
Lighting Instructions