Line Sync; Presets - HIKVISION 5 Inch Network High Speed Dome User Manual

5 Inch Network High Speed Dome User Manual
configurable to define an area. When the LIMIT ENABLE function is set to DISABLE, the movement of dome will not be limited
despite of defined limit stops. Refer to Figure 3.3.13.

SET LIMIT STOPS
To set limit stops manually:
1. Enter the SET LIMIT STOPS menu.
2. Follow the directions (SET LEFT LIMIT) displayed on the monitor and use the direction buttons to the desired location of left
limit stop.
3. Press the IRIS + button to finish the setting of left limit stop.
4. Follow the same steps to set the right, up and down limit stops in sequence according to the directions displayed on the
monitor.
The new settings of limit stops will overwrite the existed settings.

CLEAR LIMIT STOPS
The defined limit stops can be cleared by this menu.

3.3.4 LINE SYNC

This feature is not supported currently.
Note:

3.3.5 PRESETS

The PRESETS menu is displayed as shown in Figure 3.3.14.

PRESET NUMBER
The dome provides 256 presets. The PRESET NUMBER displays the preset under current operation. If the preset has been defined, the
<LIMIT SETTINGS>
LIMIT ENABLE DISABLE
<SET LIMIT STOPS>
<CLEAR LIMIT STOPS>
BACK EXIT
Figure 3.3.13
<PRESETS>
PRESET NUMBER 1
PRESET LABEL PRESET1
<SET PRESET LABEL>
<EDIT PRESET SCENE>
<CLEAR PRESET>
BACK EXIT
Figure 3.3.14
18