Chroma -Q Color Block 2 User Manual page 13

To edit the channel numbers and levels of a selected Look:
Scroll to Look Store and press Enter, scroll to desired Look and press Enter to access
the memory data. Scroll the wheel to select the channel number. To edit the channel
level, press Enter and use the scroll wheel to adjust the level (shown as 0-255). Press
Enter to toggle back to the channel number. When the desired effect is created press
Enter for 2 seconds to save Look.
Time Triggers
The PSU-05B/PSU-30 has real time triggering of the internal Looks. Press Enter and
scroll to desired Time Trigger and press Enter. Press Enter to toggle between Day,
Hour (24), Minutes and Look to be triggered, adjusting the setting with the scroll
wheel as desired. Press Enter for 2 seconds to save settings. By default Time
Triggers will occur on all 7 days unless specified. The triggers will only be activated
when the feature "When DMX is Lost" is set to Trig.
Set Day and Time
Press Enter to toggle between Day, Hour (24) and Minutes, adjusting the setting with
the scroll wheel as desired. When the Day and Time is set correctly press Enter for 2
seconds to save settings.
Display Backlight (Displ. Backlight)
The LED display can be set to go off after 5 seconds of no activity. Press Enter, scroll
wheel to On (permanently) or Off (after 5 seconds) and press Enter for 2 seconds to
save settings.
Reset to Default
Press Enter for 2 seconds to reset all menu items to factory defaults:
DMX address = 001, Control Mode = 1 (67 or 367 channels HSI+FX) , DMX Lost =
Hold, Looks = default, Display = On, Frequency = 360, System = CB2
System
The PSU-05B/PSU-30 can be set to operate for the Color Block DB4 system (CB1) and
the Color Block 2 system (CB2). Press Enter, scroll wheel to select CB1 or CB2, press
Enter for 2 seconds to save settings.
Frequency
The PSU-05B/PSU-30 has four frequency settings available - 360, 600, 1200, 2400.
This allows for the LED scan rate to be synchronised with the video camera and
avoid a flickering effect. Press Enter, scroll wheel to select frequency, press Enter for
2 seconds to save settings.
Sync Mode
In normal operation internally generated FX should stay synchronised between the
PSU-05B's/PSU-30's for approx 30 minutes. If better synchronisation is required a
timing signal can be run via a RJ45 patch (not crossover) cable between PSU's. In
order for this to work correctly one PSU-05B or PSU-30 must be designated as the
Master and all the others must be set to Slave.
Press Enter and use the scroll wheel to select Master or Slave. Press Enter for 2
seconds to save setting.
c. PSU-05B DMX Personality Mode 1-3
PSU-05B
(v2.1)
Channel 1 Grouping
0-100 Variable grouping range between 1-
20 cells with FX running within the group.
102-206 variable grouping range between
1-20 cells with FX running between the
groups.
209-255 Variable grouping range for every
2 nd to every 20
Color Block 2 User Manual
In mode 1 grouping is variable & in modes 2 -3 each cell is a group
Mode 1 (67ch)
7FX + 20 x HSI
th cells in a group.
12
Mode 2 (60ch)
20 x HSI
Hue group 1
Mode 3 (60ch)
20 x RGB
(with *Magic Amber)
Red group 1
V1.0 April 2009