Page 1
Chroma-Q ® Color One 100™ User Manual Version 1.3 July 2015, Software Version 1.5 PN: 638-0700...
Page 2
(c) by operation outside the specifications contained in the user documentation; (d) by the use of spare parts not manufactured or sold by Chroma-Q or by the connection or integration of other equipment or software not approved by Chroma-Q unless the Customer provides acceptable proof to Chroma-Q that the defect or damage was not caused by the above;...
Page 3
Chroma-Q products are safe, effective, and fully satisfactory for the intended end use. Suggestions of use shall not be taken as inducements to infringe any patent. Chroma-Q sole warranty is that the product will meet the sales specifications in effect at the time of shipment.
The new Chroma-Q® Color One 100™ LED Par features an innovative fully homogenised beam, virtually eliminating the colour separation and shadows synonymous with LED lighting. The Color One's optical design provides a smooth, uniform and defined 20° beam. The extensive RGBA colour-mixing palette delivers deep-cold blues, red-hot lava looks and super-soft pastels, all from One fixture.
Color One 100 Color One 100 Color One 100 (IP65 Version) is built with 3 feet trailing leads for power input and through; 3 feet XLR 5-pin trailing leads for DMX control data input and through. The enclosures of both models are ground bonded.
Secure the fixture with a safety bond when hung. A provision for a fixing hold is built into the fixture. 2.4 Optics The Color One 100 is built with an optical lens that provides a fully homogenised beam angle of approximately ~ 20°. 2.5 Control The Color One 100 is controlled remotely via ANSI E1.11 USITT DMX512-A protocol or can operate as a standalone unit with...
Personality: The Color One 100 features a single LED engine with a combination of 6 Red LEDs, 6 Green LEDs, 6 Blue LEDs and 6 Amber LEDs for a total of 24 LEDs. Six Personality modes are available for the control of the fixture LEDs:...
Enter to save the setting, display shows Done and returns to the previous menu • Press Exit Exit Exit Exit to return to the previous menu without saving • The display goes back to the Main Menu • www.chroma-q.com Color One 100 User Manual V1.3 July 2015...
Enter Display shows Done and returns to the Main Menu. 1-Personality The Color One 100 can be set to operate in DMX controlled and standalone modes. Refer to the list below for details. To set the Personality, From the Main Menu, press Up Up Up Up or Down...
Enter, then press Up Up Up Up or Down Down Down to select the option Down Press Enter Enter to save Enter Enter The display shows Done, returns to 2-No DMX Present and then the Main Menu. www.chroma-q.com Color One 100 User Manual V1.3 July 2015...
Down Down to increase or decrease the Intensity value or press Enter Enter Enter Enter to toggle between channels Press and hold Enter Enter Enter Enter until the display shows Recorded. www.chroma-q.com Color One 100 User Manual V1.3 July 2015...
Page 13
Down to access 4-Technical Press Enter Enter, Up Up Up Up or Down Down and select Calibration Enter Enter Down Down Press Enter Enter, the display shows the calibration values Enter Enter www.chroma-q.com Color One 100 User Manual V1.3 July 2015...
2.7 Thermal Performance The internal cooling system of the Color One 100 is by convection. When the internal temperature exceeds 75 º C, the output of the fixture is reduced for automatic protection. This happens on rare and extreme conditions when ambient temperature is over 35 º...
Symmetrical direct illumination Adjustable 1,000 – 10,000K Colour Gamut Performance enhanced Lamp Life L70 at 50,000 hours ** For exact measurements please refer to the line drawings below 4.2 Drawings – Dimensions www.chroma-q.com Color One 100 User Manual V1.3 July 2015...
5. Maintenance With care, the Color One 100 requires little maintenance. However, as the unit is likely to be used in a stage environment we recommend periodical internal inspection and cleaning of any resulting dust and cracked oil residue. If the front enclosure requires cleaning, wipe with a mild detergent on a damp cloth.