Chroma Color Block 2 Plus System User Manual
Hide thumbs
Also See for Color Block 2 Plus System:
- Quick start manual (3 pages) ,
- Quick start manual (2 pages)
Subscribe to Our Youtube Channel
Related Manuals for Chroma Color Block 2 Plus System
Summary of Contents for Chroma Color Block 2 Plus System
- Page 1 Chroma-Q™ Color Block 2 Plus™ System User Manual Version 2.2 October 2013, Software Version 2.2 PN: 603-0502...
- Page 2 Chroma-Q unless the Customer provides acceptable proof to Chroma-Q that the defect or damage was not caused by the above; (e) by modification, repair or service by anyone other than Chroma-Q, who has not applied for and been approved by Chroma-Q to do such modification, repair or service unless the Customer provides acceptable proof to Chroma-Q that the defect or damage was not caused by the above;...
- Page 3 Chroma-Q products are safe, effective, and fully satisfactory for the intended end use. Suggestions of use shall not be taken as inducements to infringe any patent.
-
Page 4: Table Of Contents
- - - Q™ Color Block 2 Plus™ hroma Q™ Color Block 2 Plus™ Q™ Color Block 2 Plus™ Q™ Color Block 2 Plus™ .......................... 4 Chroma- - - - Q Color Block Power Supply Units Chroma Q Color Block Power Supply Units ........................5 Chroma Chroma... -
Page 5: Product Overview Product Overview
Q™ Color Block 2 Plus The Chroma-Q™ Color Block 2 Plus™ is a higher output version of the original Color Block 2™ multi-purpose LED fixture that retains the same versatile modular ‘building block’ design, single colour RGBA optics, high light output and theatrical grade dimming to create an exceptional all-round feature set. -
Page 6: Chroma
Chroma- - - - Q Color Block Power Supply Chroma Q Color Block Power Supply Units Units Chroma Chroma Q Color Block Power Supply Q Color Block Power Supply Units Units 2 DMX controlled power supply models are available to accommodate most applications or operate independently as a standalone system. -
Page 7: Cabling
Cable shield/drain wire 0.25mm² (24 AWG) Only genuine Tourflex Datasafe cable is recommended for use with the Color Block 2 Plus system. Damage will occur if power connections short-circuit to data or ground shield connections. When assembling XLR4- pin cables, heat shrink should be used on each individual data pin and the drain wire to prevent short circuits. - Page 8 PSU is correctly grounded. Important Notice: The use of an opto-splitter for DMX signal distribution is highly recommended when several fixture units are not plugged into the same power source. www.chroma-q.com Color Block 2 Plus User Manual V2.2 October 2013...
-
Page 9: Fixings
Note: It is important to ensure adequate ventilation at the rear of all colour block fixtures. Never place the fixtures directly on the floor pointing upwards when configured as a batten. www.chroma-q.com Color Block 2 Plus User Manual V2.2 October 2013... - Page 10 The dual mode yoke kit for single fixture is supplied with fibre washers and thumb wheels. The dual mode yoke combines the function of the single yoke and the batten bracket. www.chroma-q.com Color Block 2 Plus User Manual V2.2 October 2013...
- Page 11 The Wall bracket for single fixture is a discreet fixing suitable for fixing a single Color Block 2 to a wall or set piece. Keyhole slots are provided for vertical or horizontal fixing. www.chroma-q.com Color Block 2 Plus User Manual...
-
Page 12: Power Supply Mounting
Color Block 2 Plus operation. 3. Press down the toggle switch to simulate the lumens output of the Color Block 2. 4. Replace the end plate. www.chroma-q.com Color Block 2 Plus User Manual V2.2 October 2013... -
Page 13: Control
Control The Chroma-Q Color Block 2 Plus is controlled via two models of addressable ANSI E1.11 USITT DMX512-A power supply units, the 5 way Color Block PSU05B and the 30 way Color Block PSU30. The Color Block PSU05B and PSU30 menu items are accessed via the LCD display and the following controls:... - Page 14 Control Mode Control Mode The PSU05B/PSU30 can be set to operate in 16 DMX controlled modes for the Color Block 2 Plus system (CB2 - Go to “System” and select “CB2”). 3 grouping options are available (single-grouped, block-grouped, all-grouped) with 5 control options: FxHSI, HSI, RGB (with *Magic Amber), RGBA, RGBI (with *Magic Amber), pre-programmed looks and standalone effects.
- Page 15 Press Enter and scroll the wheel to adjust the level (shown as 0-255) Press Enter to toggle back to the channel number Press Enter for 2 seconds to save the modified Look www.chroma-q.com Color Block 2 Plus User Manual V2.2 October 2013...
- Page 16 The PSU05B/PSU30 has four frequency settings available - 360, 600, 1200, 2400. This allows for the LED scan rate to be synchronised with the video camera and avoid a flickering effect. To set the frequency, Scroll the wheel and select “Frequency” Press Enter www.chroma-q.com Color Block 2 Plus User Manual V2.2 October 2013...
- Page 17 Slave. To activate sync mode, Scroll the wheel and select “Sync Mode” Press Enter Scroll the wheel and select “Master” or “Slave” Press Enter for 2 seconds to save. www.chroma-q.com Color Block 2 Plus User Manual V2.2 October 2013...
-
Page 18: Dmx Protocol
60 DMX channels 60 DMX channels Total DMX Channels Total DMX Channels 67 DMX channels 67 DMX channels 60 DMX channels 60 DMX channels 60 DMX channels 60 DMX channels www.chroma-q.com Color Block 2 Plus User Manual V2.2 October 2013... - Page 19 21 DMX channels 21 DMX channels 15 DMX channels 15 DMX channels 15 DMX channels 15 DMX channels 15 DMX channels 15 DMX channels 15 DMX channels 15 DMX channels www.chroma-q.com Color Block 2 Plus User Manual V2.2 October 2013...
- Page 20 9 DMX channels 9 DMX channels 3 DMX channels 3 DMX channels 3 DMX channels 3 DMX channels 3 DMX channels 3 DMX channels 3 DMX channels 3 DMX channels www.chroma-q.com Color Block 2 Plus User Manual V2.2 October 2013...
- Page 21 Amber for group 1 Intensity for group 1 4 DMX channels 4 DMX channels 4 DMX channels 4 DMX channels 4 DMX channels 4 DMX channels 4 DMX channels 4 DMX channels www.chroma-q.com Color Block 2 Plus User Manual V2.2 October 2013...
- Page 22 Light Cyan Full 62-64 Blue Full 65-68 Light Blue Full 69-71 3200 White 72-74 5600 White 75-78 Empty 79-81 Empty 83-85 Empty 86-88 Empty 89-91 Empty 92-94 Empty 95-97 Empty 98-100 Empty www.chroma-q.com Color Block 2 Plus User Manual V2.2 October 2013...
- Page 23 367 DMX channels 367 DMX channels 360 DMX channels 360 DMX channels 360 DMX channels 360 DMX channels 360 DMX channels 360 DMX channels 360 DMX channels 360 DMX channels www.chroma-q.com Color Block 2 Plus User Manual V2.2 October 2013...
- Page 24 96 DMX channels 96 DMX channels 90 DMX channels 90 DMX channels 90 DMX channels 90 DMX channels 90 DMX channels 90 DMX channels 90 DMX channels 90 DMX channels www.chroma-q.com Color Block 2 Plus User Manual V2.2 October 2013...
- Page 25 9 DMX channels 9 DMX channels 3 DMX channels 3 DMX channels 3 DMX channels 3 DMX channels 3 DMX channels 3 DMX channels 3 DMX channels 3 DMX channels www.chroma-q.com Color Block 2 Plus User Manual V2.2 October 2013...
- Page 26 Amber for group 1 Intensity for group 1 4 DMX channels 4 DMX channels 4 DMX channels 4 DMX channels 4 DMX channels 4 DMX channels 4 DMX channels 4 DMX channels www.chroma-q.com Color Block 2 Plus User Manual V2.2 October 2013...
- Page 27 Light Cyan Full 62-64 Blue Full 65-68 Light Blue Full 69-71 3200 White 72-74 5600 White 75-78 Empty 79-81 Empty 83-85 Empty 86-88 Empty 89-91 Empty 92-94 Empty 95-97 Empty 98-100 Empty www.chroma-q.com Color Block 2 Plus User Manual V2.2 October 2013...
-
Page 28: Troubleshooting Troubleshooting
Internal temperature is over the limit. Check “Fan Control” mode. Fan is not working. Check the fans and airflow - to and from the internal fan. Check area ventilation. Specification www.chroma-q.com Color Block 2 Plus User Manual V2.2 October 2013... -
Page 29: Technical Specifications
L70 at 50,000 hours Color Block PSU Color Block PSU- - - - 05B V2 Color Block PSU Color Block PSU 05B V2 05B V2 05B V2 Product Code CHCBPSU05 www.chroma-q.com Color Block 2 Plus User Manual V2.2 October 2013... -
Page 30: Drawings
Forced - 5 x fans Operating Temperature 0°C - 40°C Construction Powder coated steel Colour Black Built-In Hardware IP Rating IP20 Approvals UL 609501, CAN/CSAC22.2 NO.609501-03, UL 1573, CAN/CSAC22.2 NO.166-M1983 Drawings www.chroma-q.com Color Block 2 Plus User Manual V2.2 October 2013... - Page 31 Color Block 2 Plus User Manual V2.2 October 2013...
- Page 32 Color Block 2 Plus User Manual V2.2 October 2013...
-
Page 33: Maintenance Maintenance
Hinge kit for Color Block CHCBHP Wall bracket for single Color Block CHCBWB Single link cable for use in batten format MUCX4SDP-0.22 Other cable lengths available (‘x’ is length in m) MUCX4SDP-X www.chroma-q.com Color Block 2 Plus User Manual V2.2 October 2013...
Need help?
Do you have a question about the Color Block 2 Plus System and is the answer not in the manual?
Questions and answers